Step 2. If you have an egg prick, prick the rounded end of the raw egg to allow the air under the shell to escape. This will prevent the shell cracking when boiling.
Where do you pierce eggs before boiling?
Poke a tiny hole into the bottom of the egg before boiling it. You’ll want to use something sharp and thin to poke your egg, like a thumbtack, needle, or a cake tester. This will ensure that you don’t poke a hole that’s too big and crack the shell, or end up with the whites spewing out once you start boiling the egg.
Should I poke a hole in my egg?
It’s important to poke the hole into the fat end of the egg. This is because each egg has an air pocket at this end. And set the egg into the tray with the hole up so that this sulphury air can properly escape. You’re venting the nasty stuff that you don’t want infusing into the egg.
Why poke a hole in an egg before boiling?
When you hard cook an egg, this air heats up, expands, and escapes through pores in the shell—but not before the egg white sets. This leaves the egg with a flattened end. Pricking the egg provides a quick escape route for the air, which gives you an egg with a smoothly rounded end.
Do you put the egg in before the water boils?
STEP 1: Carefully place uncooked eggs in a single layer in a stockpot. Add cold water until the eggs are submerged under about one inch of water. STEP 2: Bring to a full boil, uncovered. STEP 3: Immediately turn off heat, remove from the burner and cover.
What is the design of egg piercer?
An egg piercer is a kitchen tool that is used to break a tiny opening in an egg shell to prevent the shell from cracking and the yolk from turning green while boiling. … They can be made of stainless steel or plastic, and some even are shaped like a hard-boiled egg.
What is the point of an egg piercer?
A kitchen tool with a sharp steel pin, usually spring-mounted, which pokes a tiny hole in the large end of an egg. This hole prevents the egg from cracking because the air inside (which expands during boiling) can gradually escape.
How do you pierce an egg without cracking it?
Wiggle the needle around in the egg to make the hole in the bottom bigger than the hole on the top. Take the paperclip or toothpick and stick it in the hole in the bottom of the egg. Gently swirl the end of the paperclip inside the egg, being careful not to damage the hole. You can also do this with a needle.
Which is the blunt side of an egg?
The blunt end of an egg has an air pocket between the inner and outer shell membranes. This gradually enlarges as the egg loses moisture during storage. Keeping the air pocket at the top helps to keep the yolk centred within the egg and prevents the air pocket from rupturing, which reduces the risk of the egg spoiling.
Do you need to pierce eggs before steaming?
There is a handy pin on the bottom of the water cup which is used to prick the eggs before cooking. This allows the steam to escape so the eggs do not explode and no, the yolks do not spill out. 2 of 2 found this helpful. … Yes, the eggs should be pricked so that they don’t crack while they steam.